Steps for adding repair solution
1
Open the Cover
When the battery is empty, pry up the battery seal plate with the included screwdriver.
2
Remove the Rubber Caps
Remove the 6 rubber caps and inject the repair fluid into the hole with a syringe
4
Inject New Solution
Let the solution stand for two hours to mix, then fully charge the battery. Finally, cover it with the rubber cap and firmly seal the cover with the included 502 adhesive.
3
Draw out Liquid
For batteries with beams, supplement the beam. For batteries without bridge, add half the capacity or 3 cm below the hole. Do not fill it up.